Research

Laser Technologies

Ìý Ìý Ìý Ìý Ìý Ìý Ìý Ìý Ìý Ìý Ìý Ìý Ìý Ìý Ìý Ìý Ìý Ìý Ìý Ìý ÌýÌý

Research Objectives

  • Research & development of novel optical sensors to make measurements that are not currently possible
    • New laser sources/detection techniques for measurement of temperature, pressure, velocity, species concentration
  • Combusion, atmospheric, and industrial research employing optical measurements
    • Fundamental characterization of difficutl environments
    • Rapid system control and optimization

Approach: Laser Spectroscopy

Light absorption by molecules is given by I/Io = exp(-alpha), where I is light intensity and alpha is absorbance. Absorbance varies with concentration, temperature, and pressure.Ìý

grouping_1

Ìý

Laser Tools

Frequency Comb Lasers

  • Emit >10^5 wavelength elements spanning 100s of nanometers of spectrum with picometer spacing
  • Boradband spectroscopy allows for detection of multi-species or broad absorbers (high P gas, liquids)
  • Together with NIST, we've built the first fieldable dual frequency comb spectrometer
freq_comb_grouping

Diode Lasers

  • Robust, compact, low cost
  • Single wavelenth output, rapidly tunable over small range
  • Capable of rapid, sensitive measurements (>100 kHz) Ìý
diode_laser_grouping

Ìý

Atmospheric Sensing

Our laboratory develops and fields frequency comb laser-based sensors for gas species and turbulence measurements in the atmosphere. We combine our sensor measurements with computational models to develop a better understanding of atmsopheric processes or in the example below, to locate gas sources.

Example: Methane Leak Detection

Mobile remote sensing laboratory providing field measurement of methane absorption. Leaks as small as 1/6 the human breathing rate have been detected from 1 km.

methane_grouping

Ìý

High Temperature Sensing

We are developing and deploying sensors to improve our understanding of high temperature environments from combustion to exoplanet atmospheres.

Example: High Temperature Absorption Database for Combustion

Controlled laboratory measurement of water absorption under gasifier conditions to build database for interpretation of subsequent field-deployed sensors.

the cell, detector, and acquisition setup at the Å·ÃÀ¿Ú±¬ÊÓƵ Rieker lab, which shows the bran link (frequency comb light from NIST) running into the phase correction. On the lab bench is the gas handling, which is connected to the optics and furnace

Example: From Nobel Prize to Power Plant

We are the first lab to deploy frequency combs for a practical combustion measurement. In this case, a 16 MW gas turbine on campus.

a diagram of a power plant that shows a dual comb spectrometer with a reference laser and spectral filter running with a combustor steam injection into an exhaust duct, a heat exchanger, and then into the environment

Ìý

Industrial Sensing

We work with industrial/scientific partners to characterize complex environments and to develop sensor-based control in these environments.

Example: Industrial Burner Characterization

  • Characterize the thermodynamic properties of the flames and heated gases above industrial burners used for material processing
  • Understand how the introduction of materials affect the flow fields
  • Develop advanced methods to fuse experimental data and computational fluid dynamics simulationsÌý
burner_grouping